To install the Argox OS214 plus printer (USB):
IMPORTANT: Promob does not guarantee that the printing labels will work with all printer models available in the market.
1. Plug the printer into your computer's USB port. Please wait while the communication driver is installed;
2. Access the Control Panel - Hardware and Sound - Devices and Printers. IMPORTANT: If you have already installed one printer Argox OS-214 ..., remove it;
4. Select the Label Dr. 200 driver (4 inch model);
5. Select the USB port where the printer is connected;
6. Complete the installation. The printer must have been installed as Label Dr 200;
7. Click the right mouse button on the printer and select Printer Properties option;
8. Click the Advanced tab;
9. In Dr iver select the Label option Dr 200 (4 inch model);
10. Click the General tab and after the Preferences button. Click the Advanced button;
11. In Paper Size set the size of the label to be used. For this select one of the preset sizes or register a new through the Customize button. The size should be the area that can be printed;
12. In Output Tray configure the type of label feed after printing. For this select the Tear off Enabled option, where the label will move enough so it can be highlighted;
13. After installing the printer perform the procedure below to print the labels on the Cut:
- Access the page Cut Pro settings ;
- Create one according to the following settings label:
- Paper: select the unknown type and enter values for width and height;
- Width: Enter the full width of the paper (A + e + f);
- Height: Enter the height of the label edges + (B + c + d);
- Lines: enter the value 1;
- Columns: Enter the value 1;
- Label Width (A): Enter the width of the label set the paper size set in step 11;
- Label height (B): Enter the height of the label set in the paper size set in step 11;
- Other settings (except Internal Margin): measure the size and inform them in cm.