Check this article for information to establish integration with Holzher machines.
Select below about one of the subjects covered in this article:
|
INTEGRATION PLUGINS Plugin Dynestic 7516 Plugin Evolution 7401-7402 Plugin Evolution 7405 Plugin Master
|
CONFIGURATIONS |
X measurement checking in Evolution plugins
Available from version:
- Plugin Builder 1.60.0.15 or higher
IMPORTANT: Settings referring to Plugins Evolution 7401-7402 and 7405.
In the Machine Setup settings, the functionality Value for checking the measurement in x, refers to the distance relative to the end of the part where the operations contained in this region will be compensated according to the actual superior size of the part.
By default, the field has the value 0 (zero). Can be set to any integer or non-negative decimal value.
EXAMPLE:
- Applied value of 150:
Value setting
To set this value:
1. Access CNC - CNC Configuration;
2. Select the machine model and after the Setup field;
The configuration of this functionality is displayed:
IMPORTANT:
- If a valid value other than 0 (zero) is entered, an extra command is generated in the programs.
- If the value is 0 (zero) no commands are added to the programs.
Command
The generated command is CALL HH MegQuote (VAL=X), where X is the value entered into the field.
EXAMPLE:
If field X has set the value 33, the generated command will be CALL HH MegQuote (VAL=33).
Drill Setup for Dynestic 7516
Available from version:
- Dynestic 7516 Plugin - 1.11.5
In the Machine Setup settings, there is the Minimum diameter to use Forstner Bit (mm) field, to establish the minimum diameter for large normal drills. If the condition is satisfied, the Normal Large Drill code will be used, as opposed to the Normal Drill code.
In the figure above, the Minimum diameter to use Forstner Bit (mm) belonging to the Normal Drill Bit field, is set to 20 mm.
Therefore, if the hole is not through and exceeds 20 mm, the code that will be used in the machine program is code 30, according to the field Large normal drill type, belonging to the subsection Drill type.
The same logic is applied to through holes, allowing for a series of combinations.
EXAMPLE:
Drilling in hinge cups:
In the example above, there are 2 types of drilling, one with a diameter of 5 mm and the other of 35 mm.
It is necessary to make the larger holes with Large Normal Drill and the rest with Normal Drill.
As none is passing, the configuration will look like this:
This is how the program is generated:
Note that the drill codes are according to the configuration.