Available from version:
- Plugin Builder 1.12.12.30 or higher
Representation in technical drawing
The representation of the edges bands in the technical drawing is made from arrows that show on which faces there are registered edges. Arrows are accompanied by the letter B and a number. This legend indicates which Structure corresponds to the edge.
When the registered edge band is not linked to a Structure, its representation is displayed only through the letter B. However, the structures of the part continue to be informed in the drawing, but they do not have a link with the edge band.
Link edge band to structure
The structures that can be linked to the edge are those that are added to the part.
On the Builder tab, when selecting an existing Edge Band or registering a new one, it is possible to link it to a structure through the Edge Band Structure property. To do this, perform the procedures below:
1. Access the Module Editor.
2. Select the desired item.
3. Define which structure will be assigned to the edge band.
